Trulieve Tabletop Vaporizer

To begin using your tabletop vaporizer device, Plug in the unit and switch the power on with the left red heat switch. Using the green plus (+) and minus (-) buttons, set the temperature at 400F. As the machine heats up, open the filling chamber and drop in the prefilled ceramic cup, metal side facing down, then place the cap back on. Place the entire chamber on top of the table top device. Device will be fully heated in approximately 3-5 minutes. The Filling Chamber as well as theTruFlower cup must be preheated for a couple of seconds before the flower starts to vaporize. Next, grab the balloon, pulling it tight, before placing the valve on the filling chamber. Before attaching, remove the Mouthpiece from the Valve Balloon then place upon your device. Switch on the airflow switch to initiate airflow. Watch the balloon carefully as it fills with vapor. Only fill the Valve Balloon with the approximate amount of vapor that you intend to use within the next 10 minutes. Do not fill the Valve Balloon completely (overpressure) in order to prevent the loss of vapors. It is important to observe the vapor density in the Valve Balloon. The balloon will be filled with translucent clouds when ready to use. Please pay close attention to which part you touch as the piece may be hot. Once the balloon is properly filled, turn off the air flow and detach the Valve Balloon from the Filling Chamber. When you do so, the Valve is automatically closed so that the vapors in the valve balloon cannot escape. Remove filling chamber from device with heat resistant tool and set aside. Attach mouth piece to balloon and cap in its place and then press against your lips to inhale the vapor from the balloon pulling it tight to completely empty it. Repeat these steps to reach your proper dosage. As the content of the Valve Balloon deflates, it may be completely emptied by stretching the Balloon taut and subsequently inhaling the content When finished power off the device with the red switch and unplug.